Fix List for A2630, Rev 4

		    March 13, 1989


	Please see example board if at all possible for a better explanation
of what the cuts and jumpers look like.


CUTS (TOTAL of 14 cuts)

	[] Cut away U202(8), bottom of PCB.
	[] Cut U307(1) and 307(2), actually cut from the IC.
	[] Cut away U307(8), bottom of PCB.  Sample shows a way to cut and
	   insert the required resistor neatly.
	[] Cut away U501(11), bottom of PCB, should take 2 cuts.
	[] Cut away U503(2), top of PCB.
	[] Cut away U600(10), U600(13), and U600(14), top of PCB.
	[] Cut away U600(15), U600(20), and U600(22), bottom of PCB.
	[] Cut away U604(1), bottom of PCB.

JUMPERS (TOTAL of 12)

	[] Attach 22 Ohm resistor to U202(8), jumper other end to U606(13).
	[] Attach 22 Ohm resistor to U606(7), jumper other end to "CPUCLK"
	   signal.  Sample shows a way to do this neatly.
	[] Attach 22 Ohm resistor to U307(8), other end to "_CPUCLK" signal.
	   Sample shows a way to do this neatly, without any jumper wire.
	[] Jumper U307(1) to U307(2), bottom PCB.
	[] Jumper U503(2) to U605(12), bottom PCB.
	[] Jumper U606(9) to U604(1), bottom PCB.
	[] Jumper U606(11) to U606(15), bottom PCB.
	[] Jumper U600(10) to U604(6), bottom PCB.
	[] Jumper U600(14) to U604(8), bottom PCB.
	[] Jumper U600(13) to GROUND, bottom PCB.
	[] Jumper U300(10) to U501(11), bottom PCB.
	[] Jumper U501(11) to U600(15), bottom PCB.
	[] Jumper U600(22) to RP201(7).

REMOVE

	Resistors:	R200,R201,R202,R600